Star Trac IP-S6331 User Manual

ABDOMINAL MACHINEIP-S6331INSTALLATION INSTRUCTIONS

Page 10

Page 11

Part No. 620-7938, Rev B., 21 Aug 2009STAR TRAC14410 Myford RoadIrvine, California 92606Telephone: (800) 228-6635, (714) 669-1660Fax: (714) 508-3303ww

Page 2Copyright 2009. Star Trac by Unisen, Inc. All rights reserved, including those to reproduce this book or parts thereof in any form without first

Page 3INSTALLATION INSTRUCTIONS1• TORQUE WRENCH ••••••••••••••••••••••••••••••••••••••••1• 8MM HEX KEY SOCKET •••••••••••••••••••••••••••••••••• #2 C

Page 42. Grip the top of the outside SHROUD and lift to remove it from the weight stack. Carefully store the SHROUD for later use. Now repeat with the

Page 5INSTALLING THE ARM PIVOT BRACKET:1. Locate the six (M12,70MM,Button Head Bolts), six (M12,Washers), ARM BRACKET, & ARM PIVOT BACK PLATE. Al

Page 6INSTALLING THE ARM PIVOT (CAM SIDE):1. Install the CAM/SHAFT assembly thru the bearings in the ARM PIVOT BRACKET and into the ARM PIVOT.2. Insta

Page 7GUIDE ROD LUBRICATION:1. Apply a general purpose lubricant (such as 3-in-1 oil) that does not contain Teflon to a cotton cloth, then run the cot

Page 8GAPSCREWSINCREMENTAL WEIGHT ADJUSTMENT:1. Check to make sure the gap between the TOP PLATE pin and the 20mm hole of the INCREMENTAL WEIGHT plate

Page 9INSTALLING THE TOP BUMPER:1. After both shrouds have been installed install the black TOP BUMPER by first inserting the two tabs (1) found on th