Star-trac S-UBX User Manual download pdf (Page 15)

620-7992 Rev 001

STEP 1.

Using a #2 Phillips screwdriver, loosen the (2)

screws that hold the front neck shroud in place

(but, don’t take them off) and pull the neck

shroud up as shown.

NSTALLING

OWER

UPPLY

-TRx

For the S-TRx Personal Viewing Screen kits (both PAL and NTSC), a power supply has to be in-

stalled on the treadmill. The following procedures will guide you through the power supply installation:

(2) Screws

Front Neck

Shroud

STEP 2.

Using a #2 Phillips screwdriver, take off the (2)

screws that hold the front motor shroud in

place, then remove the motor shroud as shown.

(2) Screws

Motor Shroud

STEP 3.

At the right side corner on the base frame

(when

on the running surface)

, there are (2) M5-thread-

inserts. Before installing the power supply, affix

a 3”-long VELCRO LOOP tape on the base and

between the (2) thread-inserts (as shown).

Then, install the power supply and secure with

(2) M5 screws.

3” Velcro Loop

(2) thread-

inserts

Power

Supply

(2) M5 Screws

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

Star-trac S-UBX User Manual Page 15