Star-trac IP-S6331 User Manual download pdf (Page 8)

Page 8

GAP

SCREWS

INCREMENTAL WEIGHT ADJUSTMENT:

1. Check to make sure the gap between

the TOP PLATE pin and the 20mm hole

of the INCREMENTAL WEIGHT plate is

3mm or less when engage.

2. If gap is greater than 3mm, loosen but

do not remove the two BUTTON HEAD

SCREWS (M6) using a 4MM hex key.

3. Slide the bracket up or down to create a

3mm gap.

4. Re-tighten the two BUTTON HEAD

SCREWS.

INCREMENTAL WEIGHT PLATE

INSTALLING THE SHROUDS:

1. Insert the SHROUDS from the top

sliding downward. The SHROUDS

have seven hooks for mounting.

Before the shroud can be slide

down into place the SHROUD hooks

need to be aligned with the corres-

ponding mounting slots found on the

weight frame of the equipment. Once

the SHROUD hooks are in the slots,

slide the SHROUD into place and verify

that the top of the SHROUD is aligned

with the top of the weight stack. If the

SHROUD is not aligned use the palm of

your hand and tap the SHROUD down

until it is aligned.

2. Repeat step 1 with the inside shroud and

verify alignment.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments